ST36A
Amplified Indoor HDTV Aerial
120.635UK
This device is suitable for use for reception of FM, DAB and DVB signals
Installation Instruction
Before set up the connection, please ensure the mains for the antenna and TV set are unplugged or switched off.
Insert the belling-lee plug (RF plug) of the device into the signal input on the back of the TV set or set-top box.
Plug both antenna and TV set to the mains supply and switches both on.
The control knob in the middle of the antenna serves as gain control and can also use to switch the antenna off by turn it to minimum gain (anti-clockwise). Please adjust the gain to midway at this stage.
To get best reception for UHF signals, face the circular dipole towards the preferred transmission tower and adjust tilt until best picture quality is shown on TV.
For VHF reception fully extent the telescopic antenna and swirl around until best picture quality is shown on TV.
Fine adjust the gain control until best quality is received.
The FM signal received by the antenna will be amplified through built in amplifier and send to the TV set through connected coaxial cable.
Set Up Tips
This antenna is fitted with built in 4G filter to eliminate 4G interference, however other interference may still exist. Therefore for best picture and sound quality we are advice not to place the antenna near source of interference such as mains cable, hair dryer, microwave etc (high power consuming appliances).
The antenna position should be as high as possible for best reception as the more the obstacles occurs between the transmission tower and antenna the more the interference will be. Also please note the best reception position may vary for different channels.
Once set up is finished avoid moving the position of the antenna as picture/sound quality may be distorted when antenna is shifted.
If reception remains poor, this may be caused by the nearby strong electromagnetic field. Please try relocating the device away from appliances and walls (mains cable inside).
Specification
| Specification | Value |
|---|---|
| Frequency range | 47-694MHz(5G) |
| Impedance | 75 Ohms |
| Reception distance | Up to 65 miles |
| Gain : UHF | 25 - 36dB |
| Gain : VHF | 18 - 21dB |
| Telescopic antenna | 2 x 381mm |
| Lead length | 1.2m |
| Power supply | 230Vac, 50Hz |
| Dimensions | 465 x 180 x 140mm |
| Weight | 650g |
Precautions
 |
CAUTION |  |
| RISK OF ELECTRIC SHOCK DO NOT OPEN | ||
| CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL | ||
This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit
This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit
Safety Notice
- Prior to use, read through this safety guide.
- Pay attention to safety warnings.
- Observe all operating requirements.
- For any items designed for indoor use only, do not operate near water or in humid environments.
- For cleaning, only use a lint-free, dry cloth.
- Install according to the specifications.
- Place away from heat sources or heating appliances.
- During placement, ensure adequate support for the product and access to controls and connectors.
- Do not obstruct any cooling vents or openings and allow adequate space for air flow.
- Use only power connections supplied with the product or suitable equivalents.
- Do not modify the equipment in any way.
- For any mains powered appliances, ensure that the mains voltage is as described in the specifications.
- Keep powered products and batteries away from the reach of children.
- In case of malfunction, water ingress or other damage, consult qualified service personnel.
- Avoid pressure or impact to the housing that may result in damage when transporting or installing this product.
- For any Earthed mains product, ensure that the power supply has a protective Earth connection.
- Keep all packaging materials out of reach of children.
Indoor use only : The "House" symbol identifes electrical equipment designed primarily for indoor use.
Disposal : The "Crossed Wheelie Bin" symbol on the product means that the product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines.
AVSL (EUROPE) Ltd, Unit 3D North Point House, North Point Business Park, New Mallow Road, Cork, Ireland
